Recent content by larry91xj

anybody wanna run slaughterhouse sunday may 16th? If so let me know and we can arrange a meeting place. [email protected][/email]

I am swapping a dana 44 out of a 87 xj into my 91 xj and was wondering if my existing driveshaft will work with the 44, I currently have a dana 35, np 231 transfer case. Any input would be greatly appreciated

I have a 91 xj 4.0, and the transmission is acting really funny. While getting up to highway speed my transmission will shift through all 4 gears and then the rpm's will drop another 6-700 rpm, just like there was another gear after overdrive. If I push on the accelerator the trans will...

I am going to swap my d355 for a d44 out of a 87 xj. Will my existing driveshaft work with this application or will I need a new one. My rig is a 91 xj, 231 transfer case, 4.0. Any input would be appreciated

I'm looking for a gas tank skid for my 91, o.e, or aftermarket is allright.

a maf sensor controlls fuel mixture, and yes it would set a seperate trouble code. The best thing to do would be to monitor the o2 sensor in the cat and make sure that it is working correctly. The possibility is there that you may have a bad cat depending on mileage. also check o2 sensor...

a low catalyst efficiency code sets when the o2 sensor in the cat inself does not get the results that it is looking for. Typically if the o2 sensor were to go bad you would get more than one code. What are you using to pull codes? Do you have the capability to monitor the o2 sensor's mv...

I have a 91 laredo 4.0 that the fuel pump gets really noisy while on the trail. It seems to only act up on initial start up after the jeep sits for awhile, 15-20 min. It also idles rough while this is happening, and I get a stale, almost sweet smell of fuel under the hood. This never happens...

i have 4 stock 15x7, 5 on 4.5 jeep wheels with some 235/75r15 firestone wilderness tires on them. wheels are the big five star aluminum with jeep printed on one of the stars, tires range from 50%-90% tred remaining. Am asking $75 for all. Will not ship, if interested e-mail me at...

does anybody know coil spring rates for stock springs as well as some of the aftermarkets??

I know I've seen it on here before but have searched and came up with nothing, does anybody have a good site with a description on the homemade swaybar disco's any help would be greatly appreciated. TIA NAXJA

you should be able to bolt the hella's right up to your existing mounts. However you might have to drill the mounting holes bigger in your bumper, for the new lights to fit, as far as the wiring goes its all 12 volts so it should work fine. Good luck.