Recent content by Kycherokee

Thanks to everyone! I have just a bit more to do before coming off the stands. Since it does go into 4 wd full time I am going to just drive it and see if some miles will "loosen" it up a bit to shift into 2 wd. I would like to change shifters but I have spent my budget on what I have done so...

Spacing on the shifter does not appear to be the problem as there is still space for the shifter to move forward towards 2 wheel.

I am in the home stretch of a multi-week project on my heap. I have changed out my axle for a LSD which has new clutches and bearings. I have done rust repair and some prevention. I also found a JY 242 TC which I put a Novak rebuild kit with new bearings and chain.The shift forks looked...

Are these OEM?

Does any know if the rear brake backing plates for 10 inch brakes on the Dana 35 & C 8.25 are interchangeable? I have the C 8.25 with bad plates and have found others on a Dana in my local JY. Looks like the should work and the Chrysler parts catalogue is not showing a different part number...

Where will you find the transmission harness conection? Where the truck is in the junk yard it is very hard to see where the wire goes from the indicator switch.

I have a 2000 Sport with a 231 TC. I want to swap in a 242 and have been accumulating the parts to do it. Today at the pull & pay I found a Limited with a 242. TC. I need the position jumper wire. My problem is that I cannot find where the jumper plugs in the engine compartment. Where...

Looking to install above axle. In my 2000. XJ. In N. Ky. Area. Not interested in aftermarket. Thanks!

In Cincinnati OH area. Wanting to swap for above axle.