Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Re: Can you swap a 1999 AW4 to a 1996 ?
Hi, I got a 1996 xj 4x4 with a AW4 transmission slipping bad and transmission shop said it need a complete overhaul . A friend of mine has a 1999 xj 4x4 recently roll over his jeep a few times and decided to parting it out . I read about If you have a...
Got a used 1996 Jeep AW4 from auto wrecker and they claimed it got low mileage and had been sitting on the shelf for 11 years . Just installed it today and everything work except that when going from D to P there is a loud brake squeaking noise inside the tranny for about 5 seconds then no more...
Although i have another used AW4 from A WRECKER 1998 XJ . bUT IF that noise doesnt get worse or effect the operation of the transmission then i guess i can live with it because it is a big job to take the tranny out when i have a Klune 4-1 underdrive with the stock np242 plus the TNT long arm...
Aw4 question , 2 weeks ago i did the Moab Fall Fling and on the way home passing through Salt Lake city I 15 and i was doing about 65 mph then suddenly my xj speedometer needle jumping rapidly between 60-85 mph and at the same time heard a loud banging noise in the drive train and lost power for...
It is actually a hybird cage . The reasons the cage is so wide , straight or square because i got a 4 year old kid that she need to sit at the back seat and in order to get the rear doors open all the way . The outside B pillar tube have to extend 7 inches away from the body and when i look at...
Hi anyone with an exo cage able to install a 1.75" tube at B pillar and able to swing the rear door open 100% without sticking out 8 inches away from the body ?
Thank you for the inputs . I got a used 240v Millermatic 180 . I will be welding inside with the big garage door open . I was reading some welding book that mentioned you need to increase the gas flow rate when welding overhead especially vertical weld . I guess i was used to the higher voltage...
Hi. with 0.23 solid wire what voltage setting and gas flow rate that you found successfully weld frame stiffeners to unibody without burn through ? Thanks
Need some mig welding unibody advices
Hi. with 0.23 solid wire what voltage setting and gas flow rate that you found successfully weld frame stiffeners to unibody without burn through ? Thanks
Thanks guys for the reassurance , i will be there 8 am Oct 5 . Just wonder before heading out on to trails . Do we all meet at campsite 65 around 8:30 for briefing in Slick Rock campground ?
Accoding to trail list , first day Oct 4 is on easy & moderate trail , Oct 7 Friday is Pritchett Canyon rated 8 . At the bottom it also mentioned " trail list subject to trail depend on turn out & interest " . I can understand that but when i looked at the past 10 years Fall Fling events . Each...