• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Killman

  1. K

    Snorkel Question........Electrical shorts????

    Alternator beeing under relatively clean water does not create accute problems. Sandy mixture does, I know by experience, and not only alternators.
  2. K

    Check out my new cooling setup

    Gojeep, or anyone else for that matter with first hand experience, is the contact angle in Dinos serpentine belt pic enough to drive alternator? For me it seems to be slightly small side compared to original contact angle of roughly 180 degrees.
  3. K

    Up-Counry springs

    Sorry, I just couldnt find topic were I was discussing this issue couple of months ago, but I promised to tell you results of my findings. I purchased Rustys 2" lift front coils and 4886186-AB rear lefs. This gave me nearly up-country height (+ 1" with +/- 0,5" tolerance) with all my gear such...
  4. K

    4.7 stroker build up help

    I have few last selections to make for my stroker. My Jeep is used for low rpm crawling so low end torq is preferred. Cam: should I use Crane #753905 with higher lift or Crane #750501? With 753905 I obviously need to change valve springs but 750501 should accept standard (existing) ones...
  5. K

    From where to find springs?

    No hits from Europe sofar. I have been thinking, springs to various cars are coming from few manufacturers. Therefore there must be manufacturing specifications to coil and leaf springs. Has anyone contacts to manufacturers or specs of OEM part number such as spring rate lbs/in or kg/mm free...
  6. K

    From where to find springs?

    Yes, I did ask in jeep.org.pl/forum, not Rajdy, and you did reply. However there has been some progress in my problem since (part no's and such). I will repply on that site when I have solved the problem.
  7. K

    From where to find springs?

    Kejtar, Official measurement is from top of front axel tube to under side of frame is 20 cm +/-13mm and top of rear axle tube to frame above 18cm +/-13mm. This is from FSM and is respected by competition inspection body. With these springs I'm after, I should (hopefully) get close to FSM...
  8. K

    From where to find springs?

    Thanks 2000XJSPORT, With the information you gave I have been able (advice retailers) to locate the springs. Price is now known, availability not yet. If it happens to be so that they are not in stock in Europe. is there any advice to whom to contact in US to get them shipped to me ASAP...
  9. K

    From where to find springs?

    I have tried to locate and buy springs to my -93 Cherokee, but dealers in Finland or in Poland (I am presently) do not recognise following springs: ZJ front springs part No. 5208 8363 GN XJ rear springs part No. 5200 2392 LT Any information about availability and price? Thanks in advance.
Back
Top