Recent content by kearnsy

found the new tps to be faulty so replaced it. The car ran well for an hour or so now I have had it throw the code p1296 manufacture control. I understand this to mean no voltage to map sensor. but as already stated I have replaced the wiring harness and it checks out okay. Any ideas

I have a 2000 xj Auto For the last three months i have had issues with starting and then when running the car will 1. fluctuating Idle 700rpm -1800rpm when stationary 2. Car Dying at running speeds 100 3. Backfiring I have had fault codes for tps, Idle air control, Map sensor both low, and...

:I have a 96 xj running -3.5 inch lift rear -2.6(average of two sides) inch lift front consisting of 40mm spring 20mm spacer(left side 3.3 inch Right side 2.6 inch)bit of sag - tryes 30.9.5 bfg ats -transmision spacers -gen 2 rubicon sway bar disconects /ajustable swaybar I have replaced all...