I guess I havent been on here for a while but I figured I'd ask a few more questions. This MJ stopped running about a year ago and I recently started to mess with this again and ive done a few more things. It will start and run for a few seconds but it acts like the timing is really...
I've got a question for you. Could a controller like this be used as a stand a lone tranny controller? I've heard that it is complicated to swap a different motor into a AW4 cherokee or swapping an AW4 into a different vehicle due to all of the wiring. I am picking up a 92 4.0 5speed comanche...
I havnt got around to doing any of this yet but this weekend im going to put a new cps in my truck. I can get it new from the dealership for 25 dollars so it cant really hurt anything. I am also going to check into the tps. thanks a lot again
Im not sure what indexing is but a guy at my dads work told him about a service bullitin that he got that explained a timing problem that they may have. He said I need to get the #1 cylinder at TDC and then take out the distribulotr and cut off two little ears so I can adjust the timing. After...
Ive got a few questions. They all relate on my truck running crappy and loading up when I sit in traffic. First off, I tested my CPS and it has 250 ohms. I know its supposed to test no continuity. Also when I tested my IAT sensor it tested about 900 ohms when it was warmed up. That number...
I work at sears in the auto center changing tires and the average psi is 32. I think your safe with 35 but if it rides rough take it down to like 30 psi.
I have two questions. What year cherokees came with the non c-clip D35's? Also what year Ford Explorers came with the best 8.8 axles? I did search and couldnt find any answers. Thanks in advance.
I was offroading and got stuck on a pretty extreme angle. The right side was up in the air about as far as it could go without rolling. It was idling for about 5 min. when I was hunting for a strap at my house. When I came back it started to smoke really bad out of the exhaust. I shut it...