Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
i am gettign nothing on this wire it has continuity to the ecm and the ecm is new so im still stuck im thinking of taking it to a mechanic around here who deals primarily with electrical problems if i can tfigure it out by wed that is what im going to do any last minute ideas
it has a module with all the same wires going to it and tehn has two coming off from the module to the coil i tried checking the coil the way mentioned but i didnt get spark i assume because there is power on both sides. the garage i took it to a week ago said they switched out coils and it...
sorry its not the crank sensor its the knock sensor i had cps on hte brain the knock sensor is broken it just pulled the connection off th esensor i pushed it back on pretty sure its getting through ok i hooked up the new computer no change i looked at a service manual and it says about checking...
also i just noticed what i think is my crank sensor is broken would this cause this problem also i dont have an oxygen sensor hooked up yet could this also be a problem
ok here is where i stand the coil is an msd that was put on by the previous owner i tried touching a ground to the negative side but got nothing but a spark at the post because both are hot i have the four wires going into the ignition control module then two coming off the top of that to my...
the coil was never disconected everything worked before with some more searching i found what appears to be a sensor that goes into the head on the left side of the motor right near the valve cover on the drivers side near the firewall there is no wire running to it and really not sure what...
i am having the exact problem on my 89 i swapped in a 96 motor and now no spark everything was good before and i used all the same stuff i replaced the cps and still nothing i need some help to i am reading positive voltage on both sides of coil during engine on and crancking
i have an 89 cherokee i swaped the block and head from a 96 in and all the sensors are from the 89 along with manifolds and injection. i cant get any spark put a new crank sensor in and i get no spark. i have power on both sided of the coil when ignition is on and while crancking i have located...
Ok About A Month Ago I Switched A 96 4.0 Into My 89. The 89 Was An Original 4.0. I Used All The 89 Wiring Sensors Intake Exhaust Fuel Injection, Distributor , Everything. The Only New Parts Where The Block And Head I Went To Start It And I Cant Get Spark. All The Wiring Is Hooked Up Grounds...