Recent content by JAFFAR3869

Thanks for the advice!! ill see what i can do!

This oil change i used 10 40w because thats what I had. I use a fram 3985 filter. I noticed this soon after i replaced the filter housing o rings a few weeks back. Not sure what brand sender, i purchased it from my local auto parts store (C.A.P) I think it was maybe around 30 bucks. I bought...

Hey guys, Just recently when I start my jeep the oil pressure gauge looks great (about 40) then when i drive it for say 5 or 6 miles the gauge goes down to about 10 or 20, even lower when idling. thing is, the jeep runs normal and has just enough oil. I replaced the sender about 6 months ago for...

hey iroc 86... how did you make the tool, im doing the same thing but i wrecked the first seal and i dont wanna wreck it again. any pics??? i would much appreciate it!!!

what about swapping H.O. injectors into a renix???? any thoughts???

I just swapped heads on my jeep. I have an H.O. head sitting around now. What can i get for it?? I know it needs valve seals. What could i get for it if I got it re done???? Any one interested?? Thanks!!!!

I own a 1990 jeep cherokee with a 4.0. Its making a tapping noise at all times, and does increase when the rpms do. My Water pump pulley was warped, So i put a new one on there thinking it was the culprit. I start it up, same noise. It def. sounds like its coming from the top end, weather it...

I have a '90 xj. it idles around about 1200-1500 rpms after a drive when you put it in park. I also tried putting it in neutral, and the same problem exsists. I have done some research about this problem and some people complain about shift problems. My tranny shifts fine. People also talk...

so ive always been about jeeps, but whats the purpose of the steering box plate, obviously to brace it, but are they known for moving? fill me in. Thanks!!!

WOW:) thanks!!

Im 16, bought a sweet Cherokee that i love(mint!!, no rust!!!), and i dont wanna do to much wheelin with no hooks. I ve looked into buying some, but they are like $75 and over, and with limited budget I want a better alternative. I attend a vocational high school and i can get brackets made...

I did the ohm test, getting virtually nothing. 4-5 if im lucky, any one know where to get some diagrams or maybe some procedures? thanks!

I had something similar on my 90 xj. I had to replace the fitting that the bulb goes into goes it was corroded and shorting out against each other causing some lights to work and others to not to. I just wired one in from the junkyard, easy.

I just did a 4.0 swap on my xj. everything was ready to go. NO SPARK!! i check out the ign. mod. and it is recieving and putting out power:) but still no coil action. I also disconnected the CPS and cranked it over. the volt meter is showing zeros, although it still looks intack. One thing to...

I just did a 4.0 motor swap in my 90 xj. im looking to see where the negative battery cable straight off the battery goes. I know that it goes on the left ( when your looking at from the front) side of the engine. Right now i have it off the bellhousing bolt that holds the tranny dipstick in...