Recent content by GruDog

Sorry about the huge pics... Photo bucket doesnt like me I guess... The coils look bad because the trac bar is not hooked up...

I need to sell my 1996 Cherokee, 4.0l and AW4. The jeep has a Dana 60 rear (Disc brakes), Dana 44 front, 4.10 gears and limited slip rear. The suspension is a radius long arm front and leaf spring rear with about 6 inches of lift. The axles were swapped in with Ballistic Fabrication parts. Tires...

Thanks for that article, I now know My outer lock nut has failed lol. As far as I can tell, the lock nut got worn down significantly but the spindle threads are fine. I guess theres a good chance this axle could have been serviced improperly which led to significant failure... Anyways thanks...

Some XJ's need a T case drop after a lift, some dont. If you drive it and notce vibrations from the drive shaft you will want to look into at least a T case drop, ideally an SYE w/ CV driveshaft. Iron Rock Off road sells a hack n' tap kit with a refurb cv shaft for $200. As for the rear, I...

Theres a TJ at one of the local shops here running a set up alot like Old Man's I havent seen it in action but every body says it works very well.

Just went out and looked at it again, the spindle nut is also chewed up, Im think this may be the point of failure as that is what retains the hub on the spindle? Correct me if Im wrong.

I just picked up a set of 3/4 ton axles from an F250 (D44/60), the D60 is a full float but the drivers side hub failed. I can pull the wheel and axle shaft completely out without unbolting the hub. inside the hub, the bearings and races are completly chewed up, the spindle, threads and axle...

Trade for a street bike?

Still have all the parts, prices OBO/trades... D44~Trade pending

Ill take $200 for the Dana 44...

Ive got a few things for sale: Dana 44 rear from XJ, 3.07 gears (I think) a little dirty actually got it from a forum member but then got a deal on one tons. $250 3 inch lift coils Rough Country I believe $30 obo 4x Rancho lift shocks for use with 4" or so lift less than 3k miles $50 for...

Im good to go, got a D44. Thanks guys

Hopefully Ill be picking up a D44 from an XJ soon, I dont think Ill be looking to go bigger than 35s on the XJ. I can already get most places I wanna go, I just want the bigger tires haha. Out at table mesa, I dont know the trail names or anything but Ive been all over that place, I grew up...

Ya, I wish I could just dump some serios money on axles ready to go but I had to fight the wife when I upgraded to Longarms... So I figure I can get away with slowly working on an axle. I was hoping to get some axles for about $500 and I was figuring I would only get one for that price but...