Recent content by Fletch85

On my 98XJ the gauges will all die untill I hit the top of the dash, then thay come back on. I heard there was a service bulletin or recall for this problem. My XJ has done it for a while and I really dont mind but Im working on a 98TJ that is doing the same thing and needs to be fixed. Any...

Heres a few pics of mine, the leaf part is easy, steering is the hardest part, Im running a dana44 with high-steer arms, good luck with that 30. I believe there are a few setups that will work with the 30, Rustys will not, but I think M.O.R.E makes a kit, and you might could get away with using...

Ive seen people use exhaust pipe.

Steering is the biggest problem, all of my conversion was cheap untill I did the steering, but still spent less then the price of a good coil lift, axles included, but it seems to flex well and Im very happy with my leaf setup.

There is an inner and outer wheel bearing, the inner bearing is in the hub, the outer bearing is still in the hub but in the back side of it.

Might have just been my Jeep, but I had the Rustys 6.5 kit and it rode like crap. Also your going to have to get an SYE and drive shaft for the rear, and to fit 35s your gonna have to cut your fender a little bit.

Whatever I get will probably be from the junk yard. I was thinking of using a NP205. Anyone ever use this Tcase in an XJ.

I think my stock Tcase is going to crap out on me soon. So I am looking for a new Tcase. I want something gear driven and something thats not going to cost me an arm&leg. And something that will bolt up to my trans or can be easily modified to bolt up.

Im running stock YJ leafs with a 2.5" AAL. Ive got about 11"s of lift, but my crossmember might be lower then some of yalls.

What?

Thet were originally for a Toyota, they are pretty much just 4ft pieces of tubing with bushings on the ends. Im going to make all of the brackets. I really just need to know the locations were my brackets need to be. (ex. above/below the axle) and Ive seen some people run little shackles on the...

Im going to put so traction bars on my 98XJ to help cut down on axle wrap. Ive already got the bars, Im trying to figure out the best way to mount them. Anyone done this before and can give me some ideas.

98XJ, 11"lift, 36" TSLs, leafs up front,dana44s front and rear locked, high-steer, and way to many parts to list, Ive got about $5,000 in mods.

THRASHER- I am running Chevy flat top knuckles with hight-steer arms and 1 ton TREs. The shackles are temporary. I will be shortening and bracing them soon. Dont remember the exact width, I want to say 32"s.