Recent content by fgcox1

Pinion setup I wouldn't mind paying $100-150 for it to be setup. I would even pull the diff and deliver it if could be in that range. Local shop where I got the spacers quoted $350. Truck is barely worth that! Wonder if noise is due to not replacing crush sleeve? I used a micrometer to measure...

'89 Jeep Comanche 4 banger, 134K miles, son-in-law ran diff dry and locked it up. On disassembly it was found that the pinion bearing welded to the shaft. Replaced ring and pinion, pinion bearings and carrier bearings. Tehnperature was over 105 that day so I used new spacers the same thickness...

Unfortunately no, the 86 has a completely different mounting structure that the 87-90's. Appreciate the thought! Tnx Fred

Was te engine a 2.5? Cruise? Tnx Fred

Have 89 MJ 2.5 ltr in Dallas, motor just about gone. Looking for replacement. Considering swap to V6. Looking for 2.8, 3.1, or 3.4. Doesn't have to be running, just rebuildable (and hopefully cheap!) Tnx Fred

Looking for full gauge instrument panel from 87-90 XJ or MJ preferably w/o cruise. Bought one from an 86 but cannot get a sppedo cable that fits. Will swap the 86 if you want. Tnx Fred

Anyone ever had to pull the inside fuse block on a late 80's Comanche or Cherokee? The clutch master cylinder shaft seal leaked and fluid ran down the inside firewall onto the connection and the block. I have pulled the blocks on Fords and Chevys but before I do it on this I wanted to check for...