Recent content by eroc37

I want it. I'm local and have cash. Pm me contact info and I'll swing by and pick it up.

Re: Aussie Locker for sale, Dana 30. Did you sell this yet? I'm interested and live just down the street!

yep... rotten intank fuel pump hose! upon discovering I had an Airtex pump, I went ahead and upgraded to the Bosch which came with a new hose! PIA fuel pump replacement later, runs like a champ! I can't even hear the Bosch pump which is unnerving considering the Airtex was louder than my...

1.5" OD tube .25 wall (1"ID) welded a 1" grade 8 nut to the top, welded the bottom to the axle tube. had a 3" circle cut out of .25" plate and welded that to a grade 8 1" bolt. top bumpstops are energy suspension poly tall bumpstops that fit in the stock location. They work great and are...

the pump makes noise like it's operating properly. this is why I didn't check fuel flow in the first place. A failed pump would make sense given the fact I parked the jeep and it would not start again.

Changed fuel filter, yes, it's on the right way... still no pressure at the rail. anything else I should check before installing a new fuel pump? Searching led me to the Bosch pump as the best?

It did but I'm not sure I trust it. I picked up a NAPA gold fuel filter I will install in a little while and recheck fuel pressure. Stay tuned viewers!

it is an aftermarket pump. I pulled the fuel line before the filter and there's flow with the key on. I've never replaced the filter but I have replaced the pump. I am going to change the filter tomorrow just because and retest. Is there a problem with aftermarket pumps I should know about...

Yep. fuel pressure is zero.

I installed properly adjusted the new switch. It turns over like a champ and quickly tries to start. the first time it caught and went into high idle like a good Renix should then the idle gradually slowed to stall (with some backfiring) Upon restart it would only catch and not run. I've...

OK, I... 1. tested the fuel pump relay - it's fine. 2. made sure the fusible link to the fuel pump relay + has power... it does 3. replaced the butt connector where the ballast resistor used to be. it looked fine but I changed it anyway just to be sure. Still no start. so I replaced the...

Ive already '86'd the ballast resistor after it disintegrated and research here told me it wasn't needed. Since my DD is a cummins, I routinely turn the key on and let the fuel pump run until it stops then turn key to start. I know the fuel pump comes on at initial key to 'run' position. Could...

89 stroker motor has been running flawlessly for months. I shut it down normally, it would not restart a short while later or ever again... Turn the key it will crank, fire, and begin to run but let go of the key... nothing. I thought I flooded it but every sign of life vanishes when the key...