• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Elohim1

  1. E

    Ford 8.8 rearend 4.10 gears

    I have a 8.8 rearend complete. All perches and shock mounts have been taken off. I was going to put it in my jeep , but I sold it. rearend is from a 98 explorer that had 50K miles on it. $400.00 email me: [email protected]
  2. E

    New M.O.R.E. 8.8 rearend conversion kit for XJ

    I have sold my XJ and do not need this conversion kit for the 8.8 rear end. It is brand new and includes perches, shock mounts, u-bolts, spring plates and hardware. Just like it came from M.O.R.E. SALE PENDING ECHECK CLEARING First emailed "I will take it" with when? and how? you will pay...
  3. E

    89 Jeep Cherokee ARB air lockers OHIO $3250

    Back up. please use email, I dont read IMS much.
  4. E

    89 Jeep Cherokee ARB air lockers OHIO $3250

    Actually I am 82. BTW, I am not asking for suggestions.
  5. E

    89 Jeep Cherokee ARB air lockers OHIO $3250

    Thanks for the inquiry?? Sawzall.
  6. E

    89 Jeep Cherokee ARB air lockers OHIO $3250

    1989 Jeep Cherokee 143,00 miles ARB Lockers ,4:10 gears ,5” lift Kit, 5speed, 4wd, High output 4.0 6cyl. Air conditioning Rustys HD Lower control Arms and mounts , C4x4 rear bumper, DPG transfer case skid, centerforce clutch, Stainless header, K&N air cleaner, Flowmaster...
  7. E

    WANTED: D35 or D44 in OHIO

    I have a Dana35 4:10 gears and an ARb air locker for $550.00. Currently in my XJ. Email me: [email protected] or call 513-523-4918
  8. E

    jeep Kaiser M35 6x6 / jeep hauler ! Ohio

    1965 M35 2 ½ ton 6x6 Turbo Diesel (desirable 1D) 37k mikes 2spd. Transfer case/air shift, Heater New Vinyl top, New brake lines, Radiator newly recored. Runs and drives great. $5900 $6400 w/ramps to load vehicle. Possible partial trade for gooseneck trailer 454H.O. crate motor or larger...
  9. E

    What year front axles will fit my 89 XJ ??

    I need the drivers side axle shaft ujoint and stub shaft for my 1989 xj with the dana 30. It has the vaccum disconnect. A parts store said replacement stub shafts are not made for these anymore. So when going to a Warn,Yukon etc., which does have a larger ujoint, requires you also to change...
  10. E

    Dana 30 yoke and ujoint upgrade ???Mine Blew!

    Great info. !!! Thanks. I can get the warn shaft for $119. I havent found price on the shaft which goes in the Hub. Are these good shafts?
  11. E

    Dana 30 yoke and ujoint upgrade ???Mine Blew!

    I have tore the universal joint and yokes out of my front axle today on the drivers side. I run 35" boggers with an ARB locker. 1)Where and what is a good upgrade for the dana 30 when replacing these parts? 2) Does the inner axle simply pull out (slide new one in) , once the hub is off...
  12. E

    Front drive shaft piece identification please

    Thats it!!! Thanks. Is that # J813 0300 ??? Thanks Chris
  13. E

    Front drive shaft piece identification please

    I have contacted parts stores and they can not come up with the part. I need to Identify the metal cap with a rubber seal inside.Its about 2" in dia. and about 1.25 long. This piece is located where the spline of the front drive shaft inserts into the shorter shaft which is connected to the...
  14. E

    What is the wall thickness of a dana 30 tube ?

    I am going to mig weld some Lca brackets onto the axle tube and would like to know the wall thickness so I can set the welder properly as not to blow a hole in the tube. I know technique comes in to play , just want to know what wall thickness is ? ThanKs
  15. E

    Broke LCA and Bracket, Who has good ones??

    Was wheeling today and broke one LCA on the drivers side and ripped off the Axle bracket on the other. I have the Dana 30 and 4-5" of lift. I have seen Rustys HD axle brackets. Are there any better and where can I find strong LCA's. Thanks Chris
See more
Back
Top