Recent content by dogman

Yes it is :)

I'll check on the rear axle and let you know what it is

I started this project 2 years ago and no longer have the ability to complete the job. It is a 1986 Jeep Cherokee XJ Laredo - almost completed project vehicle Salvage Title, currently Non-Op. Interior in good condition - Exterior paint fair 0 - Miles on rebuilt 1995 3.4L Fuel-Injected Chevy...

Thanks for the suggestions guys - the flex plate was correctly drilled for the torque converter but I have also disconnected the motor from the tq and tranny to remove that potential source. The 3.4L v6 is a 60 degree motor from a '95 Camaro. My next step is to take a real hard look at the...

I have also disconnected the torque converter to take the tranny out of the mix and the vibration is still there - using an electric fan as well.

Thanks guys, the motor itself is running very well - I'll check the motor and tranny mounts to be sure and, if nothing else, will ponder raising a mullet :)

Hi, I have just about completed my the motor swap - 95 Fuel Injected Camaro 3.4L V6 in to my 86 XJ. The Camaro motor is rebuilt and runs well and is hooked up to the original XJ automatic trans. Even though I have had the flex-plate neutrally balanced - I'm getting an engine vibration - any...

You might want to check the gas cap, if the vent is plugged it can cause that condition

I'm not much involved yet, but from what I read the chapter seems alive and well, so I'll go with the flow :) Jes for Pres Gary VP Chuck for Sec/Treas Happy Holidays

May 17th. works for me, let me know what I can contribute

Bald Mtn. Great photos! now I'm really disappointed that I could not get the time off and looking forward to joining the fun. Should have the modified wiring harness back for my engine swap next week.