Recent content by DanDXJ

Does anyone know if there is a plastic fuel tank available for a Short Bed 1990 MJ ?

Thanks for the super glue tip. I will give it a try. Hopefully I will not glue my fingers to the bulb holder. I will probably need someone else to sprinkle the baking soda while I hold the rocker switch.

Thanks for the suggestions. I am having problems finding a #37 LED bulb with a small tip to fit inside the rocker switch holder. I may just have to stay with the regular bulb - it is only 1.3 watts.

1990 XJ -I have snapped the lamp sockets on the rocker switches - Rear wiper, Trans Comfort. They no longer snap into the back of the switch holder. They use a #37 bulb. Has anyone replaced these sockets? Are there any aftermarket replacements ? I am guessing they may be unique to the XJ. I do...

Thanks for info - but is there a secret to removing the caps? Is there a snap (release) button or something? I am afraid they will break if I pry on them much harder. Thanks again

The XJ is a 2001. On the roof rack can you remove the cross rails without removing the side rails? Thanks

Well I need a new wiper motor for the 1990 XJ. The original motor is wrapped in a rubber boot. Naturally it fell to pieces during the removal. The service manual makes a statement - printed in bold - to be sure to not damage the boot. Of course the new motor does not come with the boot. Does...

Thanks for the info. It looks like both ends have the same threads. I messed up the threads on the exhaust end trying to reinstall. Hopefully I can find a die and clean the threads up. Thanks again Dandxj

Does anyone know the thread size for the RENIX egr tube? Thanks Dandxj

Understood - I was trying to avoid buying tubing and fittings, bending and flaring. With the configuration I have if I had the unions I would be done.

I am putting a dual booster in a 90 XJ. Things are going fine. I can use the four existing MC to PV lines ( 2 from old set up and 2 from the new MC ) but in order to join them I need 2 7/16 in -24 to 1/2 in-20 female unions. I have look ( NAPA,Edelmans, Inline tube,etc) but can not find these...

Just wondering - are the U-joints replaceable ?

- 1990 XJ, Power steering, AW4. The U-joints on the steering shaft are done for. So I purchased a replacement. I have a couple of questions about removal/replacement. Do I have to unbolt/remove the steering box ? The new shaft is the same length as the installed old shaft. I do not see a way to...

Sorry I meant to post in OEM forum.

- 1990 XJ, Power steering, AW4. The U-joints on the steering shaft are done for. So I purchased a replacement. I have a couple of questions about removal/replacement. Do I have to unbolt/remove the steering box ? The new shaft is the same length as the installed old shaft. I do not see a way to...