Recent content by cvlv2

I'm going to go ahead and change it. Anything tricky about it I should watch out for?

Yep, mine moves about 3/4 of an inch. By the way, this is a 1990 4.0 liter with 198,000 miles.

I am replacing my oil pan gasket, rear main seal and oil pump. While under the jeep with the oil pan off, I looked up at the timing chain. I poked at it with my finger and it seems to have a lot of 'slack' in it. The engine runs fine, but the looseness of that chain has me worried. Should it...

Can someone tell me if there is a difference between D44 flattops? chev vs ford....disk vs drum?

I think I know what I did. Might have grabbed the front output yoke off of a 242 by mistake. Are the 242 yokes a bigger shaft diameter than the 231's?

I tried trading the 207's front output flange today with a later model 231 flange. It didn't work out. The 207 front output shaft and seal are a much smaller diameter. The 231 output flange was taken from a 91. Do I need to try a different year?