Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
None of these are mine, but good finds...
Cherokee-> comanche conversion.. Actually super nice.
http://toledo.craigslist.org/cto/4182818009.html
Clean wagoneer!
http://toledo.craigslist.org/cto/4207906567.html
I did mine and it was fine. Parking brake, chock wheels, and put it in drive (engine running). Grinder with cutoff wheel will do the hack real clean as the spinning shaft gives it a lathe effect rather than hacking through the output.
The front ds you're using is out of a slushbox XJ, right...
I know bassett wheels are big in circle track racing among other things, and I stumbled across these. They seem pretty lightweight (for steel wheels), the price is right, and they're made here in the USA. Does anyone have any experience with these?
http://www.bassettwheel.com/dot.html
I run a '96 XJ, so I'm lacking in experience with the renix jeeps, but...
HO factory header and take a dremel tool to the stock airbox. Take the stock hole (sized similar to a deck of cards) and extend it toward the fender, and back. As the airbox tapers for fender clearance, taper the hole...
It made me sick to see the "before and after" shots of this... when the "after" shot was of this Comanche upside down at the edge of a creek. Short of paint, it's as good now as it was before the accident!
The under-seat mounting location would work well for me, too. If I were on some epic expedition and the Jeep were full of gear and 14 illegals, it'd make sense to mount it in a more accessible location, even for a "this trip only" basis.
x2. Napa usually pretty good, tell them you want "domestic" (made in USA) parts.
(their "non heavy duty" (aka greaseable) u-joints are made by federal mogul, as are a lot of their parts. Heavy duty u-joints are solid, so they can take more power. I wouldn't use them on a Jeep as you can't...