Recent content by cfordp

Sorry. I'm wondering with the bend in the main arm if I shortened it, if it would increase my caster. My background is in programming and somehow I never learned trig and figuring out the geometry of these arms is beyond me. The cutting and welding would be done on the short upper arm. I can...

https://www.roughcountry.com/jeep-xj-long-arm-upgrade-kit.html It's that kit with Rubicon express 5.5 coils. I measure my caster from ball joint to ball joint with a piece of metal and an angle finder. I had my buddy at NTB measure it and got the same reading. Took it to a frame shop and got...

5.5" front springs with rc radius arms. Just replaced the upper bushings because they were bad. hp30 swap on my 2000. I pulled the uppers all the way in and didn't really gain any caster (2 on drivers 1.9 on passenger, swear that's what I measured from the same spot pre shortening the uppers)...

I'll try setting the distributor again. Last time I did one it took 2 tries. I did TDS on compression stroke, 11 o'clock on oil pump, distro in at 1 o'clock to where it came down right on the bolt hole with the rotor pointing 5 o'clock at cylinder 1. But like I said I've had to do it multiple...

I pulled the pan to change the oil pump, rms, and have a look around. After priming the pump (coil disconnected), I no longer get spark. It's not flooded and has been down for a week. I did accidentally move the oil pump drive a bit when installing the pump. Troubleshooting: - Checked Grounds...