Recent content by Big_Al

Why didn't I do this two years ago? Now my wife can operate the passenger window at will. Took a total of 10 min using the above link...Al

I feel for ya. I raised my 97 about 2.75" on both ends ant opted for a homemade 1" TC drop. I think I need 1,25" drop to get the last of my vibe out. I was told that the angle of the pinion should be the same degree as the TC angle. Was going to use shims but it appeared my driveshaft may have...

How about checking at your local dealer for a safty recall. Got my 97 fixed for Free.....:sunshine: Al

Don't want to hi-jack but my 97 cargo lamp doesn't work when the hatch is open. I didn't know it was suppose to. I re-tap my key fob after it goes off to turn it back on. Where should I look for stwich, or problem? Other info in this thread is good....Al

So..... Is anything leaking from the lower side after sealing up the top? Al

If you are leaking oil at the valve cover, I'd change it first, clean off the engine and see if the oil dripping from the pan came from above. That was the case on my 97. It was running down the back of the engine and dripping from the rear main aera of the oil pan. Now if you want to change an...

New search through Google showed this link. Worth a try? Al http://jeepin.com/features/nss/

On my 97 XJ Auto trans, I can only get the reverse lights to come on if I push the shifter from reverse foward toward park. This takes the trans out of reverse. Is there an adjustment on the stwich? If so where? TIA...Al Yes, I searched for over an hour.:bawl:

From how you described the problem, I'd be surprised if it wasn't the lockout stwich. In that case the used stwich you get may have the same problem eventually. I can see the need for the lockout if you have small children but many here choose tho do the by-pass. As to the speaker, check it...

Your profile indicates you have a 98? If so before you pull anything, look under the dash where the cable connects. I had a similar problem with my 97 and it was a sticky door. (been monkeyed with) I lubed all the hinge points I could see with silicone spray and now it works but I have to rotate...

Are center bolts grade 8? I bought mine @ a local parts store and when I went to trim them off with a hacksaw they seemed pretty soft. I would think that unless your u-bolts worked loose there would never be much tension on them. If your ubolts did come loose a grade k-zillion center bolt likely...

X2 ...... ....Al

May be a silly question but is the guage still on empty? If so is the tank empty?

Look here for a pic... http://www.rocklizardfabrications.com/home_brew_budget_boost.htm

Agree with getting the angle correct. If you still have a slight vib , you can alway duct tape a weight where you suspect one is missing and take it for a test. If its what you need then remove the tape and weld it on. Well you might want to see if you have any driveshaft left after you remove...