Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
JUST replaced radiator,water pump, tstat from dealer and fan clutch.my mechanic said the elec. fans are working properly. When a/c is on in bumper to bumper. it is over heating .AS SOON asi turn it off the temp comes down in about 30 seconds. Any ideas ?
I have a 99XJ w/ 2" lift and an SYE. Would a 93 ZJ 5.2 v8 front shaft be an upgrade to run in the rear w/ my 8.25 chry.?Will it work? Currently running front 98 XJ shaft in rear.
Found problem. behind cyl. there is a white plastic housing that holds a cast cylinder that turns the electric switch part.The end of the cast is cracked in half .Right now i am starting by putting a screwdriver in plastic module.IS this a dealer item and what is it called?
MY 99XJ was starting for last week, but wouldnt engage starter til the last 1/8 " of key turn . Today started the same way once then wouldnt start again. I can hear clicking in inside fuse panel. I was able to pop out cyl. by pushing a screwdriver into bottom hole in column shroud. I can turn...
I had a bad squeal at idle only when first started, then it would go away. When i finally popPed hood to check belts , found oUt it was coming from a bad distributor.
I have a 99 XJ , AW4 AUTO W/ 231 J trans case. I picked up a front d/s from A 98 xj in great condition. I ordered my SYE from AA and he said the only problem i could have runnin the front shaft is if my 99 has 1350 u joints vs 1310. How do i measure them while still on rig. IS it more likely to...
I shaved a long thin piece of plastic small enough to fit in the round hole in frame bout 6 or 7 inches from broken stud. Slapped axel grease and stuck nut on end ,and positioned it over stud i drilled out.That worked for me.
I have researched this subject and cant seem to get a definite answer.I have a 99 xj w/ 2" lift and want to loose the t-case drop and go w/ rugged ridge SYE.Will the front d/s from a 99 XJ fit the rear without mods?