Recent content by ahyland

Heres the list i made which seems to be deleted from the earlier post ~ And heres the owners manual which doesnt match what i have but may still be useful

yeah ill add them in a new comment aswell as some from the manual

Please note I have fuse 7 removed due to the power antenna causing my battery to go flat, It draws 4 amps with key out

Interior fuse panel

Sharing this fuse panel diagram I've made I could not find anything correct online for my year The service manual had you looking at wiring diagrams to figure out what each fuse actually powers and is very vague on RHD versions

So Ive managed to fix them Cleaning the switches helped but wasn't the fix Heres how I fixed them Using my homemade fuse panel diagram since thr service manual is useless for a 95 uk I pulled out fuse 12 and found which pin on the fuse block was 0v, this pin I supplied with 18v from a tool...

Pulled the switches apart I think this might be at least part of the issue, they're all heavily corroded, will update once I've cleaned them all

Had a small play around with the switch, locked and unlocked positions , I even tried with the lock switch removed and the windows still only make a small noise and dont move Suspect my issue is with the locking switch or wires if I'm getting the same symptoms if it's in the locked and unlocked...

So I have a strange issue with my power windows 1995 4.0 limited RHD (UK) All 4 windows were working but now they have all stopped, they make a noise like they want to move and giving them a small bit of pressure by hand will get to move but it's like they aren't strong enough anymore What...

Fitted new cables for the starter and ran extra grounds from near the pcm to the battery did t bother with a ground for the starter as it seems perfect the way it is now Also ended up replacing the caps in th pcm and it's running like brand new. Still need to sort the brakes, windows horn and...

Update #2 Not sure if it just needed to "burn" off the assembly lube after the rebuild but I used a large socket to hold the throttle body open slightly so it would run at 1000 rpm for a few minutes without me needing to hold the pedal down but when I start it now it's like everything has...

Update So I connected jump leads to the body and terminal on the starter and it fired right up, which is odd because I did a voltage drop test on the starter wire and got like 0.1 volt, idk. Iv attached the exhaust so it's a bit quieter and noticed it's missing on 1 cylinder and won't idle...

I bought it with the engine in the boot so I'm not sure how it ran beforehand. I was missing most of the stuff I've replaced. It had sat for 11 years so I've done a medium rebuild on the engine etc. I did try starting spray, didn't really make a difference However I have just borrowed the...

Extra info I currently have no cooling system installed, waiting to see if it will run first in case it's all got to come out to make it do so I also have no brakes, I've put 3 new lines in just waiting on some bits to arrive to do the last one, is there some kind of safety system where I need...

When I search the pcm part number the ONLY result I get is for a grand Cherokee and not a Cherokee, has a previous owner put the pcm from a grand in a non grand? Is this my problem?