Recent content by 98REDXJ2

Current list of things I need to do: Figure out my temp gauge problem Repair the passenger side rocker and cab corner Replace my trac bar tierod end or change the whole trac bar entirely While I’m doing that I will add a small coil spacer to level out the truck some. Im still running a xj rear...

After the new wheels I adjusted my alignment only to get terrible deathwobble. It was down for a couple weeks until I could replace parts. I ended up replacing all the balljoints, axle shafts with cv style, and v8 zj tierod upgrade. found out most of my hub bolts were junk, had to weld nuts to...

I did finally get my tires mounted on my jk Willy’s wheels and put them on. I definitely like the look more and I’m sure my wheel bearings appreciate less offset too lol.

I tried another 94 cluster I had and temp gauge still wouldn’t read. Still haven’t found the problem.

Slapped some stickers on now that winter is technically over

From WF25. Hopefully this year I’ll have my jk30/44 built and swapped in before WF26 lol 😅

I’ve been driving it to work for a couple weeks now. Brakes still aren’t right but good enough to drive it. My other issue I have going on is my temperature gauge doesn’t read at all. It cycles when starting the Jeep and I’ve replaced both temp sensors on it and no change. Next when I have time...

Yes I bled it. I’ve bled the whole system a few times. I’ll be at WF with the xj.

I’m still having issues with my brakes. Pedal is soft and goes about 3/4 way to the floor before stopping when the engine is running. Only guess is still air somehow stuck in the system somewhere. It has brand new hard and soft lines, new rear wheel cylinder sand brake parts , new pads and...

Front bumper

Rear bumper

Well since my last post I have done a lot. It’s all mechanically together. Might have to replace the brake master cylinder this weekend. I build a front and rear bumper, I patched the passenger side of bed behind the cab, patched the driverside rocker and cab corner, put different wheels on it...

Done

Interior is complete for now. I bolted my seats intended for my 2door build in until I get some good skins for the seats that will be permanent in the MJ.

Solved fuel issues. It now has all new fuel lines, filter, tank, and a 94 sending unit in the tank. Running good. Started 8.25 swap. Cut all old brackets off. mocked it up under the truck after having to modify the incorrect spring perches I had ordered 🙃 I did the ubolt strap mod on the...