Recent content by 88-xj-laredo

I haven't been on here in years, so I'm not sure what has changed. But I need help finding a part number for shocks. A couple years ago I stopped driving my XJ and parked it out back due to serious death wobble. I'm pulling the Jeep out of hiding to fix some things on it and sell it. I have a...

I'm looking for a NP231. Let me know. Thanks Mark

Well I feel like a dumbass, it sounded like the ballast resistor because it was the ballast resistor, the connection had come partially undone and mud had splashed into the butt connector, so with some new grease, a new connector and some good crimping it runs again! Well sort of I lost my...

So heres the issues. I have already had the ballast resistor problem, and yes it is doing the same EXACT thing as it did then, so I bypassed that already so thats not the issue. I replaced the starter relay alst year at one point so that is still fairly new, and I replaced the ignition switch...

I haven't been on here in a while and I have no idea what to search for with this problem. So I went wheeling and did some driving so my Jeep was running hard for about an hour and then did some highway driving, I shut it off probably 4 or 5 times and it started up fine, then it was idling in...

I actually need a dana 35, I don't need the leaves though, just the axle, could you let me know if you still have it? Thanks

I am getting horrible vibrations that start around 15mph and get worse until I come to a complete stop. I have redone my front and rear ujoints, redid my front brakes and the noise is still there. It is getting really frustrating. My entire Jeep vibrates, and I can hear a noise that sounds like...

Ok so let me explain the problem that we're having. My pinion is flopping around, so the yoke is flopping around, we figured that the pinion bearing had to be set into the race to hold the pinion at center, if thats not the case then what holds the pinion at center? Do we just torque down the...

Yep, that was it, the resistor must have burnt out, thanks for the help!

Just double checking to make sure I found the right part; it's a squarish white ceramic thing helf on by one small bolt with two orange wires with black stripes on them and it is pretty far forward on the inside of the fender. Right thing? I just don't want to connect two random wires and short...

Alright I'll have to take a look for it. Every little thing helps!

So with the whole host of problems winter in NH has brought about on my Jeep from blown u-joints, exhaust parts dangling and falling off, blown pinion bearings, sticking brakes and so on, I have another problem but I want to be 100% sure about what it is first. So today I drove to school this...

Yea I guess it was yours then Tekka, the one with the NAC sticker.

I only noticed one XJ with a NAXJA NAC sticker, I was looking too, should've written my username for here on the info slip for the show and shine. A great day though!

It was a good time, your run was really good mark, especially after your driver's side shock and coil decided to come off, your spotter was one of the best of the day too. The tracker was pretty awesome in the rocks too. Saw some neat XJs there, only one commanche though.