Recent content by 4.whoa

  1. 4

    '95-96 Steering Wheel/Air Bag swap in '94-down XJ

    Did you ever get around to this? I've been thinking about it for an 87 I'm rebuilding
  2. 4

    wanting to lower my 2wd xj

    I wouldn't go over 4.5" for backspacing. you get pretty close to the rear sway mounts after that.
  3. 4

    temperature sensor locations

    Well, I can tell you that a '94 harness DOES have a plug for the rear of head sensor, so does a 95 ( I have both) but they changed the plug. its a plastic contraption, not the female "bullet" style connector. when mine broke, I switched it to the bullet type. Sorry,I don't have pics of them...
  4. 4

    my 88 Pioneer is getting a SBC 350

    That all depends on what year/type 5.7 you have, Carb or efi....... Novak adaptors has all kinds of info on all kinds of swaps.
  5. 4

    87 cooling system update

    Thanks! I'll see if I can get one tomorrow. I don't remember what year my radiator is from, but it's not threaded for a sensor.
  6. 4

    87 cooling system update

    I have an 87 Comanche that I've ditched the pressurized tank and switched to a newer style radiator with the cap right on it. the new rad. doesn't have a spot for the sensor in the tank, and from what I can find that's what controls the elec fan. my question is, will a t-stat housing sensor...
  7. 4

    Installed The Blazer/S10 Air Dam

    Thanks, to bad they aren't wider.
  8. 4

    Installed The Blazer/S10 Air Dam

    can you get some pics from further away maybe a angle shot?
  9. 4

    Mopar purple cam and lifters from summit, new valve springs, am I missing anything el

    Sorry, but that's just silly. "custom" length pushrods aren't that much and you can get shims for under the rockers very cheap. I used the shims on mine and its been fine for 8yrs.
  10. 4

    Little Red

    ^ Not true, but 1wd sucks !!
  11. 4

    Little Red

    FWIW didn't work to good for mine. I was told the molded area where the glass sits is different, I told him to do it anyway with extra sealant .....and it leaks. I tried that thin sealer that's supposed to find the path the water does, but it still leaks. not much, but a drip here and there.
  12. 4

    just wanted to share a laugh with you guys - joke thread keep em coming

    A man and a woman walked into a guest house and requested to spend the night. The owner of the guest house, Mr Ben, a born again Christian refused to allow the man and woman to sleep in the same room because they were not married. The woman explained, “he is my son, not my spouse” so they...
  13. 4

    just wanted to share a laugh with you guys - joke thread keep em coming

    On the outskirts of a small town, there was a big, old walnut tree just inside the cemetery fence. One day, two boys filled up a bucketful of nuts and sat down by the tree, out of sight, and began dividing the nuts. 'One for you, one for me, one for you, one for me,' said one boy. Several...
  14. 4

    a few stroker questions

    Just my opinion but a 4bbl doesn't look stock either. Way back when I was thinking of building one, I was planning to get a Clifford intake and run a 4bbl on my 7120 head, but I was looking for more strip than street.
  15. 4

    95 Electrical issue

    yep. checked them again today to be quadruple sure.
Back
Top