Recent content by 3pinr

I was going to go with this kit for the rebuild. https://www.novak-adapt.com/catalog/transfer-case-parts/np-231-parts And this for the shifter. https://www.novak-adapt.com/catalog/shifters/sk2x/sk2xc/

Has anyone installed the Borla header on the 4.0? Mine didn't come with any documentation that I could find. I have the header bolted up, but I'm stuck on the pipe from the header to the cat. How does the pipe attach the the rubber mount on the cross-member? The old pipe has a straight bar that...

Sold

Selling 1 pair of Hella Vision Plus headlights - used. New they run about $100 a pair. Minor wear and tear. $35 shipped to US.

16" tires generally will be more expensive than the equivalent 15" tire. Some times a lot.

There may be others but here is one. http://www.turbocity.com/product_info.php?cPath=17_53&products_id=117

The Teraflex SYE I installed last fall did not require me to install the needle bearings. I ordered the SYE and drive shaft from Off Road Toy Store. When I order it it was supposed to be an Advanced Adapters SYE. After I order it they called me back and said they were out of the AA sye but could...

I got that recall a few months back for my 96XJ. I can't seem to locate it now though. I didn't bother as I had already replaced my cat.

It is 1-1/8".

Are there replaceable o-rings in the quick disconnect for a '96? The FSM makes no reference to replacing o-rings after disconnecting. Thanks

The Ridgid 345 I bought included the dies for doing double flares. I guesss the sell it both ways.

I have found the Ridgid tool to be excellent. http://www.acehardware.com/sm-ridgid-and-reg-flaring-tool-ridgid-no-345-23332--pi-1288861.html

Yes, I am referring to the schrader valve. The new rail does not have one. My cherokee is a '96 so it isn't a Renix. If the new rail doesn't have the valve, how do you release the pressure in the fuel system.

So the next part in the long list of parts I need to replace due to rust is the fuel rail. It is leaking at the front end cap. I ordered a new one from Jeep. The new one looks like it will bolt on but it doesn't have the pressure relief valve on it. Do you think this is a problem? Thanks.

I painted the entire undercarriage by hand. I dropped the gas tank and most of the suspension was off as I was also doing a lift at the time. I wire brushed the worst rust and prepped as recommended. It was a bit of a pain lying on my back, but I got it done. We'll see how it holds up. If you...