Ok, here goes...
Im putting the project up for sale. This is a rolling chassis that is ready for you to drop in your powerplant and accessories and go!
Here are the specs:
Blackout Autosports Chassis
-1-5/8” tubing
-2-person set up
-engine mounts set up for 350 powerplant
-complete subsection with crossmembers for tranny/t-case
-complete 4-link front and rear
-108.5" wheelbase
-53" cockpit width
-Chevy d60 front, 4.56, drw hubs, lockouts, with truss for hydro cylinder(from highonda)
-Ford d60 rear, GLO truss, 2 sets of 30-spline shafts, brand new 4.56 gears (not installed)
-42” IROKs (with 4wp warranty) on 16” black steel wheels (all brand new)
-TH-350 tranny, mated to np24hd t-case, joined by GLO clocking ring
-SAW 16” air shocks(new)
-Extras:
full propane fueling system(mixer, condenser, lockoff, tank)
(1)corbeau baja seat (black)(new)
(1)5-point harness (new)
tube notcher....maybe some extra tube i have laying around
there is a bit more in the garage that i will include, just not coming to mind right now
$5500 for everything.
This is located in the triad of NC (High Point, 27262). Buyers pickup preferred. Will deliver for cost of fuel.
Please email ([email protected]), PM, or call 336.880.8080 with any questions.
Thanks! Taylor
this is at ride height
ride height
front end shot
shocks are at almost full extension, THIS IS NOT RIDE HEIGHT
another front end shot, with shocks, NOT AT RIDE HEIGHT
Im putting the project up for sale. This is a rolling chassis that is ready for you to drop in your powerplant and accessories and go!
Here are the specs:
Blackout Autosports Chassis
-1-5/8” tubing
-2-person set up
-engine mounts set up for 350 powerplant
-complete subsection with crossmembers for tranny/t-case
-complete 4-link front and rear
-108.5" wheelbase
-53" cockpit width
-Chevy d60 front, 4.56, drw hubs, lockouts, with truss for hydro cylinder(from highonda)
-Ford d60 rear, GLO truss, 2 sets of 30-spline shafts, brand new 4.56 gears (not installed)
-42” IROKs (with 4wp warranty) on 16” black steel wheels (all brand new)
-TH-350 tranny, mated to np24hd t-case, joined by GLO clocking ring
-SAW 16” air shocks(new)
-Extras:
full propane fueling system(mixer, condenser, lockoff, tank)
(1)corbeau baja seat (black)(new)
(1)5-point harness (new)
tube notcher....maybe some extra tube i have laying around
there is a bit more in the garage that i will include, just not coming to mind right now
$5500 for everything.
This is located in the triad of NC (High Point, 27262). Buyers pickup preferred. Will deliver for cost of fuel.
Please email ([email protected]), PM, or call 336.880.8080 with any questions.
Thanks! Taylor
this is at ride height
ride height
front end shot
shocks are at almost full extension, THIS IS NOT RIDE HEIGHT
another front end shot, with shocks, NOT AT RIDE HEIGHT