• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

What do you need to get done before WF?

Anyone else cutting it close? My driveshaft and new coils ship today. Still need to have the exhaust done next week.

Usually. One year I built my steering and the test drive was to attica. I was under mine last night and remembered the tail pipe fell off in moab and the muffler is hanging down.
 
Anyone else cutting it close? My driveshaft and new coils ship today. Still need to have the exhaust done next week.
Oh like normal I am. Still haven't touched the jeep yet. Did get it started up the other night but that's about it. It seemed to work ok out in moab last time we had it out so might not even screw with it and just run it. Still even has full tank of fuel in from moab.

Sent from my SM-G950U using Tapatalk
 
Here’s my list! Getting close!!! I think I’m going to order some JCR rain rail roof brackets (or whatever they’re called) and maybe(?) build a roof rack before WF. We shall see!!!

de90b9c10e4a73322d3ed3875e0e1fb1.jpg

f2c46965b0eb3fe93c051138f043c180.jpg
 
Gunna be a rough one but hoping to make it.

Pass Front Stiffener
ORI hoops and axle mounts
Engine bar
Reroute pdc and computer
Front bumper and winch hook up
Finish front axle link welding
Shorten track bar
Paint
Hydro ram and brackets
Steering box brace
Trim fenders more
Extend driveshaft
Remount fuel tank and battery
Rear stiffeners and shock towers
Rear bumper install
Rear leaf shims
 
-Adjust brakes on trailer - they work.
-Clock transfer case - Done
-Add smooth skid/belly plate - Done
-Fix leaky tire - Done
-Fix oil leak at filter - Done
-Check all fluids - Done
-Replace filter on transmission - Done
-New plexi windshield - Built - Installed
-Replace one LCA bushing - Thursday???
- Replace hubs - Thursday???
 
Last edited:
Yes I'm cutting it close as well.. Finished up front brake line (ran ss braided line down track bar to a T block on the truss and hard lines out to the calipers) hydro assist and steering today. Still need to cut the front driveshaft down, get the 37s mounted and hope I don't have to do a whole bunch of trimming, run air line from compressor in the back to the front locker, and run all the wires for the compressor
06371076f171041f6bfc3959920154b0.jpg


Sent from my Pixel 3 XL using Tapatalk
 
Got the roof rack done and the front and rear diff fluids changed. Just need to pack clothes and spares and I’m 100% ready to go!!!

f02e5036884acf088e10c1c04ed6393c.jpg
 
Gunna be a rough one but hoping to make it.

Pass Front Stiffener
ORI hoops and axle mounts
Engine bar
Reroute pdc and computer
Front bumper and winch hook up
Finish front axle link welding
Shorten track bar
Paint
Hydro ram and brackets
Steering box brace
Trim fenders more
Extend driveshaft
Remount fuel tank and battery
Rear stiffeners and shock towers
Rear bumper install
Rear leaf shims

Some how finished all of this besides paint.
 
Back
Top