5.5" front springs with rc radius arms. Just replaced the upper bushings because they were bad.
hp30 swap on my 2000. I pulled the uppers all the way in and didn't really gain any caster (2 on drivers 1.9 on passenger, swear that's what I measured from the same spot pre shortening the uppers).
My upper arm measurements are 1" shorter than RC recommends (14 3/4 with no adjustment left. RC baseline is 15 1/4) and 30 1/2 on the main (3/4 longer than RC baseline).
I know there is caster correction built in. Would I gain caster pulling my entire arms shorter?
hp30 swap on my 2000. I pulled the uppers all the way in and didn't really gain any caster (2 on drivers 1.9 on passenger, swear that's what I measured from the same spot pre shortening the uppers).
My upper arm measurements are 1" shorter than RC recommends (14 3/4 with no adjustment left. RC baseline is 15 1/4) and 30 1/2 on the main (3/4 longer than RC baseline).
I know there is caster correction built in. Would I gain caster pulling my entire arms shorter?