joeyschribar
NAXJA Forum User
- Location
- Edmonton
is it important to have your frame stiffeners all 1 continuous piece all bent up to fit the rails, or could you section them.
what i planned on doing was using as much as i could, and where it bends up, cut a piece and weld it in.
then overtop of both plates, fishplate it.
to me it seems a whole lot easier then trying to have 1 huge intricate bend piece of 1/8 plate!
what i planned on doing was using as much as i could, and where it bends up, cut a piece and weld it in.
then overtop of both plates, fishplate it.
to me it seems a whole lot easier then trying to have 1 huge intricate bend piece of 1/8 plate!