NAXJA Forums -::- North American XJ Association  

Go Back   NAXJA Forums -::- North American XJ Association > NAXJA Events > NACFest 2018
HOME Member FAQ Sponsor Info Rules Bylaws E-Mail

NACFest 2018 June 21st - 23rd, 2018 at Rausch Creek Off Road Park, Tremont, PA

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old April 16th, 2018, 16:54
STROKER's Avatar
STROKER STROKER is offline
<-- A Tribute
 
Join Date: May 2002
Location: in my own little world, jus' dunno where it's at
Posts: 1,424
Are you ready

Since it is about 2 months out, wanted to see who is ready and who is still working on their stuff.

I’ll start.
Need to finish building the front axle and install it, welding needs to be done, gears, order front shafts(RCV’s)...ouch...and order front drive shaft.

Should be done in time...I hope

STROKER
__________________
MJ done...when we wheelin w/4.6 STROKER
Friend of Matt #17
.
RAUSCH CREEK
Reply With Quote
  #2  
Old April 17th, 2018, 12:11
Rob Mayercik's Avatar
Rob Mayercik Rob Mayercik is offline
NAXJA Member #920
 
Join Date: Jun 2002
Location: NJ, U.S.A.
Posts: 1,996
Re: Are you ready

Done:
- Replace HVAC blower and fan speed resistor pack
- Install protective boots on my winch disconnect connectors

Goals:
- Reinstall wire tail for winch to battery(removed to do boot)
- Install tie-back lanyards for swaybar discos
- Redo headliner (Bonus: relocate CB to mount between visors instead of wedged between console and RF seat, run mic extension down to dashboard)
- Repair passenger-area floorpans
- Repair cargo floor/lower quarter panels
- switch tail light harnesses to 97+ sockets/bulbs

Would like to get to:
- Get driving lights working again (replace relays/fuses, check wiring)
__________________
1992 Cherokee Laredo: "A wonderful balance of grace and rust"
1984 Dodge Omni
2002 Volkswagen Jetta GLS TDI
Reply With Quote
  #3  
Old April 17th, 2018, 17:06
Rock2pus's Avatar
Rock2pus Rock2pus is offline
NAC VP
 
Join Date: May 2009
Location: Malaga NJ
Posts: 1,862
Re: Are you ready

Rob I have those sockets and bulbs my 98 doesn't need them anymore
Reply With Quote
  #4  
Old April 18th, 2018, 13:58
Rob Mayercik's Avatar
Rob Mayercik Rob Mayercik is offline
NAXJA Member #920
 
Join Date: Jun 2002
Location: NJ, U.S.A.
Posts: 1,996
Re: Are you ready

Oh, I already have a set of harnesses and bulbs - got them a while ago from a part-out. Just haven't had time to actually put them in so far.
__________________
1992 Cherokee Laredo: "A wonderful balance of grace and rust"
1984 Dodge Omni
2002 Volkswagen Jetta GLS TDI
Reply With Quote
  #5  
Old April 20th, 2018, 13:59
chedisme's Avatar
chedisme chedisme is offline
NAXJA Member
 
Join Date: Dec 2007
Location: middletown, NY
Posts: 5,454
Re: Are you ready

I'm hoping to start the spring over swap on my YJ this weekend.
Then I need gears lockers and an sye.
Honestly I doubt I'll finish. But if I don't I'll just take the xj.
__________________
Pics Vids
Quote:
Originally Posted by sheepjeep View Post
he demonstrated how a helicopter works thats the real reason he didnt get the cop job
Reply With Quote
  #6  
Old April 23rd, 2018, 18:25
STROKER's Avatar
STROKER STROKER is offline
<-- A Tribute
 
Join Date: May 2002
Location: in my own little world, jus' dunno where it's at
Posts: 1,424
Re: Are you ready

Ok, welding is done, thank you Rock2pus
still need gears setup
order front rcv shafts done thank you rcv
order front drive shaft done thank you Adams Driveshafts

STROKER
__________________
MJ done...when we wheelin w/4.6 STROKER
Friend of Matt #17
.
RAUSCH CREEK

Last edited by STROKER; April 24th, 2018 at 05:18.
Reply With Quote
  #7  
Old April 27th, 2018, 09:09
XJwonders XJwonders is offline
Huh, what?
 
Join Date: Aug 2014
Location: Aston, PA
Posts: 463
Re: Are you ready

What front axle are you building?
Reply With Quote
  #8  
Old April 27th, 2018, 12:11
STROKER's Avatar
STROKER STROKER is offline
<-- A Tribute
 
Join Date: May 2002
Location: in my own little world, jus' dunno where it's at
Posts: 1,424
Re: Are you ready

Hp44. It’s been in my garage for years sitting.

STROKER
__________________
MJ done...when we wheelin w/4.6 STROKER
Friend of Matt #17
.
RAUSCH CREEK
Reply With Quote
  #9  
Old April 27th, 2018, 12:35
XJwonders XJwonders is offline
Huh, what?
 
Join Date: Aug 2014
Location: Aston, PA
Posts: 463
Re: Are you ready

Didn’t u already have a 44 in the front?
Reply With Quote
  #10  
Old April 27th, 2018, 12:39
XJwonders XJwonders is offline
Huh, what?
 
Join Date: Aug 2014
Location: Aston, PA
Posts: 463
Re: Are you ready

What I need to do to get ready is to find a tow to Rausch. Lol. I’m getting tired of driving it back n forth.
Reply With Quote
  #11  
Old April 27th, 2018, 18:23
STROKER's Avatar
STROKER STROKER is offline
<-- A Tribute
 
Join Date: May 2002
Location: in my own little world, jus' dunno where it's at
Posts: 1,424
Re: Are you ready

Quote:
Originally Posted by XJwonders View Post
Didn’t u already have a 44 in the front?
Yes but it was a low pinion and “thrown” together also the bridge over the pumpkin snapped.
__________________
MJ done...when we wheelin w/4.6 STROKER
Friend of Matt #17
.
RAUSCH CREEK
Reply With Quote
  #12  
Old May 16th, 2018, 15:55
xcalibur223's Avatar
xcalibur223 xcalibur223 is offline
NAC President
 
Join Date: Jan 2006
Location: long branch, nj
Posts: 1,789
Re: Are you ready

Start Jeep and make sure it still runs
Change oil
Measure and order new rear driveshaft
Bleed brakes
Hope brakes work
__________________
Quote:
Originally Posted by Begster View Post
(And don't listen to a big red head who looks like hellboy, and answers to the name Ross, he doesn't actually know what he is doing!)
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
not ready for SYE yet Djmack Modified Tech Discussion 11 March 5th, 2010 08:24
Getting ready to buy a 95 XJ Drunkencat OEM Tech Discussion 4 May 12th, 2009 20:39
I`m Ready for Oct 15 hards91xj NorthWest Chapter 35 October 20th, 2005 06:58
Are you ready?! Glenn B Non-Tech / Off Topic 4 October 24th, 2003 12:19


All times are GMT -7. The time now is 21:42.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
NAXJA and NAXJA logo's Copyright NAXJA. All content/images Copyright NAXJA 1999-2014