2012 Nac-Fest Swap Meet thread

post up what ya got forsale/trade/wanted/free whatever


97-01 drivers side tail light in good shape-free
ubolts for a 8.25, 9/16 thick (your either gonna need to drill out stock ubolt plates or make new ones)-$20

im sure ill have more crap before then

bunch of stuff i can bring at request

stock leaf packs (inverted - mains in good shape for bastard pack - free
stock coils - free
shocks - rears are rough country nitros, fronts are monroe - make offer
stock trackbar and bracket in good shape - no death wobble - make offer
ZJ sway bar - no bushings - free
stock steering box - needs rebuild (output seals), but no play in gears or shaft - free
stock jensen dash knee panel tweeters - best offer
(4) stock 10 hole aluminum wheels - 15x7, 5.25 BS - good shape no leaks - $20/ea obo
Clayton trackbar drop bracket with 2"o.d. cross-frame brace welded to it - fits 2.5" JJ - $90 obo
Custom trackbar for OTA setup - fits the above bracket - requires axle side mount. 2.5" JJ at frame side, 2" JJ at axle side - $50 obo (buy with bracket above for $125)
4* aluminum shims - $10
Marker light off passenger side (pre-97) - $5
gas cap - free
spare tire pin - free
Rear CCV Hoses - free
Roof rack bracket (just the pastic - no latch) - pre 97 - free

one basically brand new 235/75R15 Firestone Destination M/T - >2000 miles on it, still has nubbies on the sidewalls. Also has a puncture on the shoulder lug so no good for patch/street use. Tube it and have a brand new trail tire - $50 obo

trackbar and bracket noted above:

-Corba 29XLT CB with the mic, antenna cable, and an antenna that's no use to me anymore. $50
-Misc 97+ interior pieces, pretty much everything except the dash. Priced from free to beer
-Also have a 97+ center console. $20
-97+ cruise control servo thingy, EVAP stuff, ac compressor. $beer

Ross ill take the cb stuff!

i already sent him a PM

bwahahahahahahahahahaaaaa

Dam

in case it doesn't make it home

everything on my rig

(kidding, I hope)

OE coils off my 01...free to a good home
black hood off my 01...paint has that funny crackly thing going on, but no rust or dents..20
LP D30 out of my 01...no outers, shafts, or balljoints..3.55/open, very clean..40
OE steering parts from early and later years..one of the draglinks is brand new...pm with needs and ill bring up what ive got.(ends too)
RE swaybar relocation brackets-10
Upper front control arm bushings (axle side)..one set rubber/steel shell, the other urethane, all new...5 bucks for the rubber, 10 for the 'thane
misc. hatch inner parts (wiper motors, lock solenoid, handle, etc...PM me with needs.
HP 44 with waggy width 3-1/2'' tubes, Solid Axle inner "c"'s, and undrilled Chevy flattops..nothing yet welded, housing is empty no diff no gears no shafts...350 OBO
Rich

zj tie rod, ends need boots replaced, will include poly boots for 20bucks, pm for pics....

I have and can bring to NACFest for any interested parties:

Warn T-Case Skid $60
Daystar Poly Tranny Mount for AW4 $20
Steel Roller Fairlead $10
Rusty's Trackbar and Bracket $60

4 35x1450 16lt pitbull Mad Dogs 85-90% on black steel wheels 5x5.5 bp- $1000 obo

I have two front doors that came off OverlandXJ's old olive drab XJ. Doors are in good shape. I was going to use them, but never got around to it and now need them out of the garage.

Free if you guarantee you'll take them.

Dont you have like 3 garages at your new place?

WANTED: NOS stuff for 1987 XJ

Crist Clapper said:

WANTED: NOS stuff for 1987 XJ

Click to expand...

Tell us your needs, Grasshopper. Perhaps we may be of service.

NOS?



:rof:

lobsterdmb said:

I have and can bring to NACFest for any interested parties:

Warn T-Case Skid $60 - MrShaft696
Daystar Poly Tranny Mount for AW4 $20
Steel Roller Fairlead $10
Rusty's Trackbar and Bracket $60

Click to expand...

Make an offer if you are interested in any of the other stuff.

Ill take the fairleed

I have the stock steel wheels and tires that come off my 1999 Suburban 2500.

Free if anyone wants them.

New Old Stock

dukie564 said:

NOS?



:rof:

Click to expand...