View Single Post
  #1  
Old September 15th, 2019, 00:17
bajabronco bajabronco is offline
NAXJA Member
 
Join Date: Apr 2013
Location: los angeles, ca
Posts: 244
Installed the Yukon Super 88 C clip eliminator kit today on my Ford 8.8

I finally got around to installing my Yukon Ultimate 88 C clip eliminator kit today in my rear Ford 8.8 in my XJ. It is a fairly easy install if you take your time. The hardest part was using my crappy slide hammer to pull the axle bearings on each side of the axle. It did add 2" to my rear axle, which now makes it 1" wider than my front D44.- I think that might be the only down side to the kit. I only got a couple pics of pulling the backing plate, cutting the axle housing to the flange, and then installing the new bearing seat.




Reply With Quote