View Single Post
  #8  
Old February 24th, 2007, 14:01
jmop jmop is offline
NAXJA Forum User
 
Join Date: Mar 2004
Location: Salem, Oregon
Posts: 418
Re: My NP435/203/205 swap

Here is an initial cut for the new tranny, this hole will get much larger.



I installed and pulled this bellhousing several times fitting everything, as well as figuring out the slave cylinder mount. The slave bolts to the DS side of the bell housing. There is one through hole and one tapped hole. I had to drill a small hole for the fork spring but for the most part it bolts right up.
Reply With Quote