terryd
NAXJA Forum User
- Location
- Elk Creek/Covington Va
Well, I've finally gathered the materials for my front tow points. I'm using plates that incorporate the steering box and factory bumper bolts on the sides, with a piece of angle iron on the inside of the two tabs on the front of the body where the bumper bolts up and a piece of 2.5"x2.5"x.250" box between them behind the front bumper.
Now I'm trying to decide whether I should poke two d-ring tabs through the bumper between the factory bumperettes or trim the bumper a little in the middle below my license plate and put a 2" receiver tube there, or just do both.
Here's a quick sketch of roughly where they would come through the factory bumper.
Now I'm trying to decide whether I should poke two d-ring tabs through the bumper between the factory bumperettes or trim the bumper a little in the middle below my license plate and put a 2" receiver tube there, or just do both.
Here's a quick sketch of roughly where they would come through the factory bumper.