• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Spring Meet and Greet Swap Meet

Air tools and renting a strut spring compressor from your local auto parts store can really help too.

Air Tools- Check
I was hoping to not have to mess with those compressors again if possible.....
 
A few things I have laying around the garage:

Snap-On tool box 6'x4'x2'deep $1200
1 97+ intake complete-50
1 95 intake off 4.0-50
1 complete engine rebuild kit with new oil pump(no rings) standard size
1 4.0 crankshaft fresh out of machine shop-80 standard bore
1 Starter-20
1 alternator-30
1 complete 4.0 with hole in block but all accesories still on engine

anything you want just let me know, probably won't bring all the stuff but it is less than a mile from the park we will be at
 
How big od a hole and how did it get there? does it run otherwise? how much are you asking?
 
I've got a freebee for the kids. My boys have out grown their jeep wrangler power wheels. It doesn't have a rear bumper, no roll bar lights. Has a good battery and charger.

bring the jeep my son will love it

the hole in the side of the block is about the size of my fist, a connecting rod went through the side of the block. Apparently the young girls jeep this came out of did not have the warning label about making sure there is oil
 
i have 2 hubs and rotors from a TJ and 2 stock TJ tie rods with both tre's and drag link from TJ's. I ll bring em to see if anyone wants them

Mark
 
We need to have a few tables set up for everyone to throw parts on to sell and trade. Seems like many people are bringing stuff thats already sold plus some.
 
I may have some stuff laying around too.
 
I might have some 15x10 aftermarket aluminum wheels; I have to check the bolt pattern; it's either 4.5 4.75 or 5 inch....not really sure.

I'll get pictures and more details up after work on tomorrow morning.
 
I have some fox body mustang seats (power).Ands some worn out 31x11 thornbirds.Make offer or prob. wont bring.(no room)
 
I may have some stuff laying around too.

Went through the shop and found these:
2--hitches
set of '97+ tail lights
RE Monotubes shocks rear for 5.5"
steering stabilizer
cup holder for center console early model
t-case skid for 231 Rusty's I think
RC t-case drop kit
RC rear ext stainless brake line 4.5" NIB
center console for 97+ agate color
front driveshaft-needs new ujoint

Items for a Ford Ranger
Add a leaves for a ford ranger
full set of Fabtech shocks for a ford ranger
Lighted Sun Visor for a '97 NIB

maybe a couple other things.
 
Let me know if your interested in any of the items I have or I'm just gonna leave them at home. I'm already bringing enough stuff and people so the less I need to load up the better.

2 pairs of manual front doors both black with manual windows and locks. One door has a slight dent in the middle of it (Passenger Door). If anyone is interested in the doors and would like a pick I will nab some and email them to you. $25 each.

Computer from a 91 cherokee 4.0 ho $20

Passenger tail light: $20

Stock rear leaf shackles: $5

Full gray dash board, good condition from a 91: $20

2wd AW4 tail shaft housing: Free

2 4wd AW4 computers: Free

Stock front and rear sway bars: Free

Jeep wrangler power wheels (grey and black) Free
 
I will have the following if anyone is interested.

-Front BDS shocks for 4.5" lift (missing top bushing & plate) $20
-ZJ front driveshaft $15
-Ford 8.8 stock diff cover $10
-Braided steel brake lines $25
 
Back
Top