• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

The "Hope I get it done by WF Oh-Ten" thread

Build TCase skid
Weld cage to floor
Swap winch bumpers from '91 to '96
Purchase remote for TMax winch
Install CO2 bottle bracket
Build rear tire carrier
Install swaybar (hoping Santa brings an Antirock)
Swap stereo into '96 so the Sirius works
Install CB and tune antenna
Install seats and harnesses (sitting in the kid's bedroom)
Buy another trailer
Drive :)
 
get floors
get lift
get tires
get wheels

i got a ways to go

All you really need is a Floor and some rocker protection! Unless there is snow on the ground of course!
 
my list.
-1) buy a wheel and mount my spare
0) cb radio
1) rocker protection
2) fab up a gas tank skid weld it to my hitch
3) find an 8.8 and make it fit.
4) regear to 4.56 or 4.88's
5) ox locker (front or back? cant decide)
6) find a motor for my rear pass side window so i can remove the duct tape
 
- Install 231 w/SYE
- Raise rear shock mount on axle
- 2x6 Tubing for Rockers
- Mount spare tire bracket on roof rack
............. I'm sure there is more but thats all I can think of right meow.
 
Been working on it. Got the replacement gearbox on the jeep. Got a set of turbine wheels and some used tires. It rides soo smooth now.
Still need to... Get a fullsize spare tire, Find axleshafts for my nondisco axle, swap the non dicsco D30 and replace worn front coils, Towpoints, fire extinguisher, First aid kit, Maybe budget boost
 
winch for the front bumper
maybe have a custom AJ rear tire carrier in.
also i may have a CJ-7 to bring along that i hope to buy this spring
 
winch for the front bumper
maybe have a custom AJ rear tire carrier in.
also i may have a CJ-7 to bring along that i hope to buy this spring

On that note I need to install my newly acquired(soon to be anyways) ARB bull bar and maybe a winch.
 
Assuming I find someone to harass into going with me (or for that matter decide to go):
* put new wheels/tires on Jeep, possibly throw a smallish spacer+shackle lift in
* wire up the CB the rest of the way
* build front/rear bumpers...
* drive.
* (non critical) get the OHC and its temp sensor installed, get the SYE done.

EDIT: where do I register, if perchance registration is still open? Assuming I decide to go.
 
Last edited:
I am thinking about installing a new CB after this past weekend, mine simply is a piece of shit.....
 
We will be looking for someone to make a registration page for us. If you can or know someone willing to help, let myself or a MWC BOD member know.

Registration usually goes up roughly a month and a half (if not a tad earlier) before the event, and usually closes 2 weeks prior.
 
Hope i get a sye or t-case drop so i can make it down there major drive line vibes right now
 
Lift
Tires
SYE (If I have vibes...)

So far, nothing accomplished...

PS. Anyone have some old 31's that are decent, I might be willing to buy em if ya bring em to WF... PM me...
 
Bumper is done and I'm ordering my Trackbar, T-case drop and Tie rod within the next couple weeks!
 
Back
Top