iwannadie
NAXJA Forum User
- Location
- Gilbert, Az
I replaced the high pressure line on my moms sable and refilled the fluid and I tried bleeding it. I first with the car off, ignition on, wheels off the ground and worked the steering lock to lock for a minute or so. Checked the fluid and it didn't go down at all. Then, disabled the ignition, cranked the motor for a few seconds and fluid still didn't go down much if any. Had someone start it and turn it right back off, it sucked the fluid dry instantly. I refilled and we started it again and worked the wheels, fluid bubbled a lot. We let it run for a few minutes working the steering but it never really stopped bubbling / foaming.
Is there a different way to bleed the fluid on this thing? Should it be fine and work the air out on its own? Will it damage the pump with that much air trapped in it?
Is there a different way to bleed the fluid on this thing? Should it be fine and work the air out on its own? Will it damage the pump with that much air trapped in it?