Now how the hell did I bend that?

Ok, sometime between the last Cherokee Crawl up in Harlan to last week I have bent the hell out of my t/case cross member and the Rustys t/case skid as well.

SO.....

Yeah need a replacement cross member. Any one running a home built or aftermarket piece?

Just looking for some feedback.

Specs.

96 XJ, 2 Dr, AX-15, NP 231.

I had so much "bend" that it almost put the cat and muffler into the floor pan.

thanks

buzz.

This is what I am running.

https://www.hooliganoffroad.com/collections/xj/products/xj-cross-member-tcase-skid

That is pretty nice. I didn't even know that one existed.

Ghost said:

That is pretty nice. I didn't even know that one existed.

Click to expand...

Neither did I, was very pleased when I found it. Definitely like the clean look of it, and gaining 1" of ground clearance.

Also a nice building block to add a transmission skid for those of us with the auto.

I've seen only the Rusty's one. It's no where as nice as that. I told Andy at Ironman, after my son bent two, that I needed him to make one that we could not bend...... It's not hard to bend them actually.