I have access to some material and machinery tomorrow. Sort of late notice and no access to my xj to take measurements. I want to build some mounts for inside the coil, similar to the T and J kit. Any one have any input? I figure the bottom closest to the spring is 4" to 4.25" od with a 2.25" Id. Use 2.25" Dom to fit the 2" bumpstop. Top is the same as bottom but with a flat side with about 4.375" to 4.5" from tip to flat edge. Figure make the plates out of 3/16“
Does that sound about right? Sorry for the late notice.
Does that sound about right? Sorry for the late notice.